Since the circuit makes use of Philips TV remote for device-switching time parameters, you need to know the fundamentals of the coding format used in these IR remotes.
The Philips IR format makes use of RC5 code, which is also known as ‘bi-phase coding.’ In RC5-coded signals (Fig. 2), each bit has a uniform duration. A transition in the middle of the time interval assigned to each bit encodes its logical value (‘0’ or ‘1’). A high-to-low transition assigns the bit a logic value of ‘0,’ and a low-to-high transition assigns the bit a logic value of ‘1.’ We need additional transitions at the beginning of each bit if a stream of equal bits is sent. However, there is no need of additional transitions if the next bit has a different logic value.Table II shows how all the commands of an RC5 remote control are encoded.
The first two bits are ‘start’ bits, which are used to adjust and synchronise the receiver. These bits are used to calculate and analyse the bit length of the other bits. The third bit is a ‘toggle’ bit, which is toggled every time a button ispressed at the remote control. This bit is used to identify whether the button is really pressed or whether an obstacle came in between the IR path of the remote and the IR receiver.
The five bits (A4 through A0) immediately following the toggle bit are used to identify the device (see Table III). So, a maximum of 32 devices can be identified to and respond individually to the same type of coding without any disturbance, i.e., one among the 64 devices can be identified uniquely. Addresses of some of the remotes are shown in Table III. The six bits (C5 through C0) immediately following the five address bits are the control/command bits. Therefore a maximum of 64 commands can be equipped in an RC5-type remote. Some of the command codes (decimal equivalents), as used in this project, are shown in Table IV. When any of the command/control buttons on the remote is pressed, the coded signal is received by the IR receiver-demodulator TSOP1738.The output of the IR demodulator circuit is normally high, but when any of the buttons in the remote is pressed, a stream of low-going demodulated pulses will appear at its output. These pulses are fed to the external active-low interrupt input pin (INT/0) of 89C52. On receipt of the first low-going pulse, the monitor program of 89C52 will get interrupted and jump to the location ‘0003H,’ where the execution is redirected to ‘receive’ sub-routine of the
program.
The outputs from the subroutineare:
1. Toggle bit, which toggles (either ‘0’ or ‘1’) each time the button in a remote is pressed.
2. Address byte, whose value is zero for a normal Philips-type TV remote control.
3. Control byte, which has a unique value for each button in the remote control.
Download Project 
No comments:
Post a Comment